Search:   

PLL Perforated Linear Fluorescent
 

NOTE: Designer linear fixtures are custom built to order. Extended lead times and minimum ordering quantities may apply. Please contact Customer Service for additional information.

Downloads
Spec Sheet






Application
This fixture is designed for suspension mounting for direct/ indirect applications where aesthetics and performance are both needed. Virtually glare free and shadow free illumination.
Features
Designed to mount on exact 4 foot, 8 foot, and 12 foot centers. Joiners will accept stems, single cable, and power cords as supplied by Horizon. Two die cast aluminum architectural ends available (Spade, Bull Nose). Optional lamp sleeves are available that allow for the adjustment of the up/down light produced by the fixture (order one per lamp).
Construction
Heavy gauge roll formed steel housing with perforated pattern. Units are shipped with die cast aluminum joiners installed for suspension and structural continuity.
Finish
All reflective surfaces are finished with a high reflectance, lighting fixture white polyester powder.
Electrical System
ETL listed. Suitable for damp locations. Damp location emergency pack must be specified separately. Ballasts are solid-state electronic. Ballasts and lamp holders are replaceable without removing from ceiling. Discrete voltage must be specified for emergency pack options when wired with flex.

Please consult factory for availability & pricing of fluorescent & HID fixtures.

Or click picture below to be directed to Internal Directory Page