Search:   

PWL Perforated Wall Mount Linear Fluorescent
 

NOTE: Designer linear fixtures are custom built to order. Extended lead times and minimum ordering quantities may apply. Please contact Customer Service for additional information.

Downloads
Spec Sheet



Application
This indirect fixture is designed for wall mounting applications where aesthetics and performance are both needed.
Features
Designed to mount to a wall bracket (provided) that compensates for uneven surfaces and allows for recessed electrical boxes. Louvers give a better than 45 degree cutoff to the lamp. Forward throw design optical system maximizes the output of T5 and T8 lamps.
Construction
Heavy gauge roll formed steel housing with slots covered by an opaque overlay. Units are shipped with die cast aluminum joiners installed for structural continuity and for attaching other units for continual runs or end caps.
Finish
All reflective surfaces are finished with a high reflectance, lighting fixture white polyester powder.
Electrical System
ETL listed. Suitable for damp locations. Damp location emergency pack must be specified separately. Ballasts are solid-state electronic. Ballasts and lamp holders are replaceable without removing from ceiling. Discrete voltage must be specified for emergency pack options when wired with flex.

Please consult factory for availability & pricing of fluorescent & HID fixtures.

Or click picture below to be directed to Internal Directory Page